Outback Power Systems FLEXware 500 Instrukcja Użytkownika Pobierz pdf (Strona 7)

A complete FLEXware 500 System consists of the following in addition to the FW500-AC

and FW500-DC:

• FLEXware Mounting Plate (FW-MP)

• two FX Series Inverter/Chargers

• AC Conduit Adapter (ACA) and a DC Conduit Adapter (DCA), which connect each FX to the

FW500-AC and FW500-DC

• MX Charge Controller(s) (normally part of this system) and mounting brackets

• AC and DC breakers including a specic AC Input/Output/Bypass Breaker (IOB) Kit

per installation

• bus bars and DC current shunts as required per specic installation

• DC and AC ground fault protection

Some systems will work optimally with an FW-X240 Auto-Transformer installed.

Note: Be sure you have all the parts required for your intended system installation. As every

installation is dierent, consult with your dealer or installer for further information.

FLEXware 500 Parts List

FLEXware 500 consists of the FW500-AC and FW500-DC. Each is an aluminum chassis for mounting

AC and DC breakers, respectively, along with the components listed below:

FW500-AC components:

• aluminum enclosure

• DIN rail bracket

• Breaker and Bypass Mounting Bracket

• TBB-GROUND

• ex nylon conduit and ttings

(conduit runs between the FW500-AC

and FW500-DC as needed)

FW500-DC components:

• aluminum enclosure

• 500 amp shunt with TBB attached

• TBB-GROUND

• FW breaker bus

• DC Breaker Mounting Bracket

• FW500-DC Hardware Kit

• DC positive bus bar

• jumper wire from DC negative to ground

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Brak uwag

Outback Power Systems FLEXware 500 Instrukcja Użytkownika Strona 7